pslop.blogg.se - Acpi compliant control method battery driver hp

#Acpi compliant control method battery driver hp drivers
#Acpi compliant control method battery driver hp windows 10
#Acpi compliant control method battery driver hp code
#Acpi compliant control method battery driver hp Pc

#Acpi compliant control method battery driver hp windows 10

Microsoft ACPI-Compliant System driver missing W7 64 - Windows 10 Forums.

#Acpi compliant control method battery driver hp drivers

Battery Drivers Download amp Update For Windows 10, 8, 7.

#Acpi compliant control method battery driver hp Pc

Microsoft ACPI-Compliant System Driver Download - PC Matic.

ACPI-defined devices - Windows drivers | Microsoft Docs.

Plugged in, not charging, Win 10 - HP Support Community.

Consider adding parts of those solutions to your method as well if you still have issues and are certain both your battery and AC adapter are not defective. Boot to Windows normally and the battery should now be charging and reading correctly in the system tray.Īs I mentioned, I had tried a variety of commonly suggested solutions before draining/charging/recalibrating my battery seemed to be the correct solution. After chkdsk completed I was able to boot to Windows 8 normally. If you have this issue as well, my solution was to tap F8 at boot to get to the Start-up Recovery Menu, booted in Safe Mode, ran Command Prompt and scheduled Chkdsk c: /r for next boot, then rebooted.

#Acpi compliant control method battery driver hp code

At this point I actually booted to a BSOD with error code 0xc000021a and had to resolve that issue separately before I could boot to Windows normally to check on the battery issue. reconnect the AC adapter and allow the battery to charge with the laptop still powered OFF for about 2 hours or until mostly charged. I recommend leaving it shutdown and disconnected from the AC adapter for an additional hour. let battery discharge to 5% and Windows shutdown automatically. Check Device Manager to confirm it is still uninstalled or uninstall again if necessary. If Windows did shutdown/sleep and you had to reboot, the Microsoft ACPI-Compliant Control Method Battery Driver may reinstall itself upon reboot. disconnect AC adapter - Windows might shutdown/sleep/hibernate immediately if it thinks your battery is low/critical, if so leave AC adapter disconnected then reboot and run on remaining battery power (even if meter reports 0% as mine did).

This might be the time to uninstall the Microsoft ACPI-Compliant Control Method Battery Driver in Device Manager - DO NOT SCAN FOR HARDWARE CHANGES AFTER DRIVER UNINSTALL COMPLETES change power settings in Control Panel to not shutdown/sleep/hibernate on battery power, then set critical battery power shutdown to 5% so battery can nearly fully drain. NONE OF THE COMMON SOLUTIONS WORKED FOR ME, though it's possible they played a role in part since I did attempt them first. My laptop's battery is "non-removable" so I even removed the bottom of the laptop case to inspect the battery and attempt solutions requiring battery removal (cable disconnect, rather than using the pinhole button on this laptop model). I tried every solution recommended on various forums from Acer to HP to Dell - most of which focused around uninstalling the "Microsoft ACPI-Compliant Control Method Battery" driver, disconnecting the battery, discharging residual power, rebooting, etc. However this proved to be a software/operating system issue and the battery was fine (I was still able to boot and operate Windows 8 with my AC adapter disconnected). I had this same issue on my Acer Aspire ES1-711 laptop with "non-removable battery" - system reported battery at "0% plugged in, not charging". Detailed method here:ĪLTERNATE SOLUTION - battery needs to be fully drained, then recharged, and thus recalibrated to the operating system. Draining, recharging, and recalibrating the battery worked for me. Had the same issue on my Aspire ES1-711 and tried every possible solution suggested around the web.